Hi! This module can be used but keep in mind there's no control in the current available for LED. To control the current you should put resistor in serie with LED. Best regards.

Hi! Ok! I hope you can return coming soon. Happy new year! Best regards.

Hi! The initial problem with LED circuit was solved? Best regards.

A room or space with level white painted dividers can be utilized as a "Develop Room" or a develop tent could be bought of manufactured. The fig trees would even now should be adjusted to Sunlight in spring on the grounds that the LED Lights don't deliver UV, which would harm the leaves...

Yes, 100 Ohms.

Hi! Welcome Bulent! You can control T5 using timers. You can use this driver but not as shield because pins 2 - 6 are used for touch screen. Connect the pins using wires. Best regards.

Hi! I'm sorry for my misunderstanding and bad words. I have deleted the last two posts. I hope see similar action from you. We can keep talking about this build when you show me your Ferduino controller parts. Best regards.

Hi! Click in "accept this answer" next to right answer. Best regards.

[quote=" Fernando Garcia » Mon Oct 31, 2016 7:52 pm ":11xw6cki]In fact I think better use only the code below because Ricard did changes to control the power supply via web interface using the ozone reactor variables. Add in "Ferduino" tab: const byte desativarFonte = FREE PIN;...

Hi! Both can work with Ferduino but there an important difference, the white driver from AC-RC is for 1000 mA and from Mean Well is for 700 mA. The white driver can produce some noise due the PWM frequency but it can be fixed on code, anyway I think the Mean Well driver the best option. Best...

Hi! Yes, YOU can use an IRFZ44N but the IRLZ44N will give a best control because works with logic-level on gate. Best regards.

ok Fernando working perfect thanks again ^:)^ ^:)^

Hi! There two solutions possibles above to 1A. Best regards.

Hi! I found this pictures on Portalpez (spanish forum), Ricard did a great job. Congrats! Best regards.

I think better use a LDD but, there many people using MOSFET. Here an example:

[quote=" Fernando Garcia » Today 1:36 pm ":2psbom74]Search before ask please. gracias

Hi! With 3 wires fan you can't control the speed. Best regards.

He was not wearing tip . What I did was a plate with LM324 to amplify the 5V to 10V and then put the green cabre from source to gnd , the purple of the PWM source and yellow font did not put him in any way because these sources and carry 10v is the yellow cable. So is the scheme that I got to...

I'm using mean well LDD 1000H

OMG! Not at all! When the LEDs are in parallel the current increase and voltage stays the same. When the LEDs are in serie the voltage increase and current stays the same. In others words for 4 LEDs in serie the voltage is 48V and current is 1A. As you have 8 series in parallel the voltage is 48V...

must have ground from 5up back to ferduino, when there is a supply there must be a return. oops.

Hi! Welcome Daniele! Use a MOSFET to each channel as on this circuit. Best regards.

You need of 1 heatsink and cooler PWM like this . You need ask the LED's datasheet to the seller. The Aliexpress say: Forward Voltage: 30-36V Forward Current: 300mA/600mA So you can use a LDD-600H .