Thank you. I am too tired to be editing code i-) so I have not paid enough attention to what I was doing I was looking for where to change the names of the timers using the search function and I think i replaced "timer" with "" I have changed it to config_timer and...

Ignore that, sorry. You were right of course ^:)^

Hi! Firstly the best way to know if a code is fine is sending to board and test it. If you have changed the setup as explained here should be right. Remember that pin numbers for PCF8575 goes of 0 up to 15. Regarding analog pins check it: Best regards.

If have the new ezo stamp, with ezo on the bottom left. You first have to change the baudrate from 9600 tot 38400. You do this by running the test code for the stamps and open the port of the stamp you want to use. Then enable carier return in the serial monitor. Then enter SERIAL,38400 , this...

Hi! Glad to hear. Best regards.

Hi Adrian! Thanks for your reply. Your table is incomplete like mine. :) The last string is: prog_char texto259[] PROGMEM = "DESLIGAR WAVEMAKER";// tabela_textos[259] Could you complete it? Best regards.

Hi! Glad to hear. All this information is on forum just search a bit. Best regards.

[quote=" Fernando Garcia » 21 minutes ago ":34qzjh1m] Please use tags to post any code here. Check the wiring and use a code for test first. I tried it.. I checked the wires but in the router it does not appear DHCP like device. Can the device be wrong? (w5100) Is it normal that the 2...

Glad to hear!

The code is right. Should be problem on touch. The temperature is updated to each 60 seconds. The value is an average of 12 readings.

The search is your friend.

[quote=" Fernando Garcia » Yesterday 7:34 pm ":timpepz7] Almost the same is different of equal. I can't see it in your previous code: void iniciar_stamp_densidade() { Open_channel(ec); // To open channel for salinity delay(50); Serial3.print("R"); // To get a value...

You're welcome. Let me list the problems. 1º You can't use IDE from .exe file should be .zip. 2º Even after uninstall the IDE the files with libraries settings remais in .../documents/arduino.

Great fernando, that's right :ymapplause: Norberto Pinheiro

Sorry willy the program won't what I thought, I have to do one tab at a time :| -------------------------------- Last edited Thu Dec 18, 2014 12:08 am -------------------------------- Sorry willy the program won't what I thought, I have to do one tab at a time :| --------------------------------...

The problem to connect to the Joy-reef is solved. Latest version of ferduino loaded and a made the changes necessary to work with my setup. Still small problem regarding dosing pumps , but have to look into that Len

Hi! You bought the SD card of 1 or 2 GB as I told in last time? Ferduino_English isn't compatible with Ferduino Mega. The code was done to the ethernet controller ENC28J60. Best regards.

Thank you Fernando.

fernando thank you . here is the screw shield.

Thanks Fernando

Check the comments on code.

hi Fernando . a big thank you I tested it when I receive my new Arduino because I accidentally blown the 3.5 V circuit :-B kind regards .

[quote=" Joyreef » Yesterday 9:03 pm ":1sk32q4t] Simone, non può essere :D quel valore può essere un intero qualsiasi, quindi non può cambiare se metti 20 o 35. Cerca il problema da qualche altra parte! It can't be... search for the problem somewhere else! devi aggiugnere una { (...