TFT Shield [SOLVED]

[Toni Torner]

Fernando Hi I have a problem with the implementation of the project I use an Arduino Mega and I get it moving asks you to insert the SD card , you get to keep saying anything is inserted sd card
thanks

[Fernando Garcia]

Hi!

Welcome Toni!

Which TFT shield you are using?

Have you checked this topics?

viewtopic.php?f=24&t=41

viewtopic.php?f=24&t=36

Best regards.

[Toni Torner]

In Fernando Hi , thanks for answering , the screen is ITDB02 V1.1 , I removed the pins 50 , 51 , ​​52 , 53 , the shield of the TFT and I made the bridge between pin 4 and R16 . I've left it as it comes to le potentiometer 10R , as I understand it by the Terms and screen . Also I try to say that the screen without the ethernet shield .

-------------------------------- Last edited Sat Feb 21, 2015 5:55 pm --------------------------------

Hi Fernando, thanks for answering , the screen is ITDB02 V1.1 , I removed the pins 50 , 51 , ​​52 , 53 , the shield of the TFT and I made the bridge between pin 4 and R16 . I've left it as it comes to le potentiometer 10R , because I understand that by contrast screen . Also I try to say that the screen without the ethernet shield .
Excuse me for my English, which is very bad , I hope that 's understand
thanks again

[Fernando Garcia]

If you haven't an ethernet shield the pins 50, 51 and 52 are needed for SD slot on TFT.

[Toni Torner]

Hello again Fernando, gifts now connect it back again the pins 50 , 51.52 to test if it works for certain what format should sd card and what size you being 64 Gbytes .
Thanks .

[Fernando Garcia]

The size should be 1 or 2 GB!

[Toni Torner]

Connected the pins 50, 51, 52 to the TFT shield and it works now I need test the touch. Thanks