![Image](http://www.robotshop.com/media/files/images/w5100-ethernet-network-module-1-large.jpg)
You need to do the connection below:
Check this topic to see how use the SD slot on TFT.
To use an ethernet shield with w5100, you need connect on this way:
Notice that the pins 10, 11, 12 and 13 are not plugged.
To complete pins that are missing, you can make it:
To prevent conflict between SD card from TFT and SD card on ethernet shield, you must remove pins 50, 51, 52 and 53 of the TFT shield.
![Image](https://farm9.staticflickr.com/8022/7679774708_cea7138e4b_z.jpg)
![Image](https://farm8.staticflickr.com/7269/7679776116_0ca27758d8_z.jpg)
Then make a bridge between R16 and pin 4 as shown in the image below.