Forum Software Ferduino code Pumps pin

Pumps pin


Post Number:#1 Post Tue Feb 06, 2018 7:34 pm
Posts: 33
Topics: 10
Images: 8
Solve rating: 1
Joined: Wed Jan 10, 2018 7:30 am
Topics: 10
Age: 44
Gender: None specified
National Flag:
Italy
hello fernando,
I'm a bit 'confused about the use of the bomba1, bomba2, bomba3.
unfortunately I can not understand the translation well.
I need to connect the return pump. I think I understand that the bomba1 is for to restore the evaporated water (controlled by sensor2 and sensor3).
I have connected the pump pins to the relay but bomba2 and bomba3 remains switched off. could it be that they do not come on because I have not yet installed all the level sensors?
thank you
Last edited by Juan Macchi on Tue Feb 06, 2018 7:52 pm, edited 1 time in total.

Post Number:#2 Post Tue Feb 06, 2018 7:51 pm
Posts: 1699
Topics: 38
Images: 301
Solve rating: 233
Joined: Mon Mar 03, 2014 5:59 pm
Topics: 38
Age: 39
Location: São Paulo
Gender: Male
National Flag:
Brazil

Hi!

As I told before this pumps are for partial water change (PWC).

I think you should search for ATO.

Look for "void reposicao_agua_doce ()" function on code.

The pin used is: solenoide1Pin

Best regards.
Post your doubts on forum because it can help another user too. Just PM me for support if it's absolutely necessary.

Post Number:#3 Post Tue Feb 06, 2018 7:54 pm
Posts: 33
Topics: 10
Images: 8
Solve rating: 1
Joined: Wed Jan 10, 2018 7:30 am
Topics: 10
Age: 44
Gender: None specified
National Flag:
Italy

Post Number:#4 Post Tue Feb 06, 2018 8:00 pm
Posts: 1699
Topics: 38
Images: 301
Solve rating: 233
Joined: Mon Mar 03, 2014 5:59 pm
Topics: 38
Age: 39
Location: São Paulo
Gender: Male
National Flag:
Brazil

There's no control for return pump.
Post your doubts on forum because it can help another user too. Just PM me for support if it's absolutely necessary.




Return to Ferduino code





Who is online

Users viewing this topic: No registered users and 1 guest

cron