Problem to install ferduino with web control [SOLVED]

[Antonino Ferreira]

Hi, I am unable to install ferduino with web control. I downloaded the latest version on github, compiles normally but when you run is the message in the LCD: "Please insert a SD CARD".

I have already put the card into the slot LCD, the ethernet shield W5100 and is always presenting this message. What can be?

I appreciate the help.

Excuse my English, I'm using google translate.

[Fernando Garcia]

Hi!

Welcome Antonino!

Did you the bridge between pin 4 and R16 as explained here?

The ethernet shield is connected as explained here?

Best regards.

[Antonino Ferreira]

Thank you Fernando, I forgot these procedures, I will do this and give the return.

Pin 4 connected to the R16, the R16 I drop a tip of his board?

[Antonino Ferreira]

Fernando, did the procedures indicated me only now when I turn on the LCD is on the screen to enter the password but the touch is not working.

I was with out a doubt, the bridge pin-4 to R 16, the bridge is to stay in the resistor or on the board?

Tank you.

[Fernando Garcia]

You need CUT or NOT weld the side of the resistor that goes to pin 53.

[Antonino Ferreira]

The following pictures of how I made the connections, the LCD is on the password screen and the touch is not working.

youtube a video of the operation

Watch on youtube.com

tank you

[Fernando Garcia]

Hi!

Are you using this line on code?

Code: Select all

UTouch      myTouch(6,5,4,3,2);

Best regards.

[Antonino Ferreira]

Fernando, I made the change in code, which is only now appearing to "Please insert the SD CARD" message. What can be now?

When the code is uTouch myTouch (7,6,5,4,3); , The touch does not work and is on the password screen, when I change to uTouch myTouch (6,5,4,3,2); is requesting the card.

I put the memory card in both the LCD and in the ethernet shield W5100.

What can be now?

Thank you.

[Fernando Garcia]

Use this line:

Code: Select all

const byte ChipSelect_SD = 4;

[Antonino Ferreira]

Hello Fernando, now it worked, but now the date and time are not displayed. It presents xxxxxxxx0 of 2000 xxxxxxx 00:00:85

How to fix it?

I've been in the time and date menu, adjust but not working.

Thanks again for your help.

[Fernando Garcia]

This questions are very basic and have answers on forum already.

Use this line:

Code: Select all

DS1307 rtc(20, 21);