I have a question aboy the ato function.On the home screen of the ferduino with webcontrol code is a a message which says ATO = on or off is the a function in the menu where you can turn this on or is it always on.
I translated the following comments i guess that its has to do something whit the ato function is this correct ?
Code: Select all
const byte sensor1 = 54; // A0; // Analog pin that checks to see if there is voltage on the buoy from quarantine.
const byte sensor2 = 55; // A1; // Analog pin that checks to see if there is voltage on the buoy bottom of sump.
const byte sensor3 = 56; // A2; // Analog pin that verifies that there is tension in the upper float sump.
const byte sensor4 = 57; // A3; // Analog pin that checks to see if there is voltage on the buoy bottom of reservoir.
const byte sensor5 = 58; // A4; // Analog pin that checks the level of the reef.
const byte sensor6 = 59; // A5; // Analog pin that checks the level of fish only.
const byte bomba1Pin = 60; // A6; // Pump that draws water from quarantine.
const byte bomba2Pin = 61; // A7; // Pump that draws water from the sump.
const byte bomba3Pin = 62; // A8; //That puts water in the pump sump.
Is it correct that bomba3pin is for the pump that fills the sump by the ato function and that sensor3 when its free triggers the pump to fill the sump (bomba3pin).
Sensor4 is for the empty signal of the reservoir that fils the sump.
Could you please explain this to me and what the function is of the other pins.
kind regards Len